- the flash was created for that size and is referencing the wrong user_init and certificate flash locations
- the locations the OP used to flash the above were not correct for the larger flash size
Explore... Chat... Share...
softfoot wrote:The chip is a 25Q32 and is reported as 32Mb so I tried 32Mbit-C1 ---- on a reboot all I got out of the serial port was garbage.
In the end after going around in circles web searching and getting conflicting info on the meaning of the "-C1" I tried the 16Mbit-C1 settings and it worked!
So, my question is given my chip is a 25Q32 why on earth do I have to use 16Mbit-C1 ???
I think the 1.7 'prebuild' binaries are for 16Mbit flash,
and the esptool would flash it right with addresses for 16Mbit flash.
Yes, and nothing. STA to AP mode is fine, but if […]
It also depends a bit on how you intend to use it.[…]
11/14/2019, Version 2.3 Project has now been code[…]
It should work, see this: https://github.com/esp82[…]
are you able to solve these issue??
Thank you for this fast reply. My code is pretty […]
Can you "Talk" to the ESP directly (usin[…]
I had the same problem. The exception code hints a[…]
That confirms my suspicions that I can have a clon[…]
Hi, I have two ESP8266 modules, both are in STA+A[…]
Thanks a lot !
Some GPS modules can be polled and will immediatel[…]
Hi, versions from 2.5 up are "experimental&qu[…]
In Python, a string is a single-dimensional array […]
hi... i am trying to develop a *tiny* esp+arduino […]
I personally got a "similar" issue havin[…]
Hi, Some time ago I made a project with John Lass[…]
Is it possible to program the ESP8266 to behave as[…]
That's why I went back to SPI mode. And that you […]