-->
Page 2 of 2

Re: NodeMCU + enc28j60

PostPosted: Thu Mar 19, 2020 7:50 am
by Logrus
JurajA wrote:and do you have some server at IP address 192.168.0.1 port 5000?

try the WebClient example of the Ethernet library (comment out lines with compilation errors)

No, I don't have such a server, but my concern is in getting an address from DHCP server. I don't understand why NodeMCU does not get the address.

BTW, if I reset NodeMCU it gets the address and it works. :o What could cause such a behaviour?

Re: NodeMCU + enc28j60

PostPosted: Fri Mar 20, 2020 1:12 am
by JurajA
Logrus wrote:
JurajA wrote:BTW, if I reset NodeMCU it gets the address and it works. :o What could cause such a behaviour?


powering

Re: NodeMCU + enc28j60

PostPosted: Sun Mar 22, 2020 5:38 pm
by Logrus
JurajA wrote:powering

Powering of what? NodeMCU or enc28j60? Right now NodeMCU is powered by my workstation's USB-port via USB-interface. enc28j60 is powered from 3v3 of NodeMCU.

Re: NodeMCU + enc28j60

PostPosted: Mon Mar 23, 2020 1:18 am
by JurajA
Logrus wrote:
JurajA wrote:powering

Powering of what? NodeMCU or enc28j60? Right now NodeMCU is powered by my workstation's USB-port via USB-interface. enc28j60 is powered from 3v3 of NodeMCU.


the NodeMcu 5 V to 3.3 V regulator then must feed both power hungry chips. if the enc28j60 module has a 5 V VCC, then use that