ESP8266 Community Forum

Hi Guys, in tasmota I wanted to get event switch state and then run a command but i couldn’t do that in rule, what am i missing?
Rule1 on power1#state=1 do event chkswitch=%sw[1]% endon on event#chkswitch=1 do power1 0 endon
When power1 is on it says backlog event chkswitch=%sw[1]% and event done but power1 not off

You do realize this is the ESP8266 forum?
I think you'd better ask people that actually are more into Tasmota.

Tasmota runs on esp8622, that's y i asked if anyone gone into the wild tasmota

Tasmota is easy to use. By the way i found solution in tasmota chat group, thanks for your replies