ets Jan 8 2013,rst cause:4, boot mode:(3,6)
load 0x4010f000, len 3584, room 16
Also if I try to open the Serial monitor on 9600 baud rate and try to print to it, it's printing unknown characters
The onboard LED flashes every 10-15ish seconds and every time it flashes it seems that code in the loop section has been run. I ran esptools.py flash_id command and this is what I got:
Found 2 serial ports
Serial port COM7
Detecting chip type... Unsupported detection protocol, switching and trying again...
Detecting chip type... ESP8266
Chip is ESP8266EX
Crystal is 26MHz
Detected flash size: 4MB
Hard resetting via RTS pin...