below configurations are good?
VCC -> 3.3v
GND -> GND
RST -> Pull up 10K
EN -> Pull up 10K
GPIO15 -> Pull down 10K
GPIO0 -> Pull up 10K
GPIO2 -> Pull up 10K
Please confirm above is minimum requirement to run an ESP12,
thanks
Explore... Chat... Share...
Moderator: igrr
It takes about 20-25 seconds for home assistant c[…]
I tried to upgrade tof my sonoff basic R2 with the[…]
a problem Perhaps you want to define "Probl[…]
Rebooting your router will not give you a faster I[…]
There are no other notifications from esptool.py i[…]
Using the Arduino IDE, you'll learn how to set up […]
In this project, you will post to Twitter using an[…]
In this project, we will build a water level contr[…]
I guess I'm late, but I had the same problem and f[…]
Last night I received my first D1 Minis for a lear[…]
Although I am aware that this is an old post, I fe[…]