Hello, i've been following the progress of this post for a long time, i thought i should give it a go, but i don't have nodemcu board yet, but i do have esp-12. I would like to know if this is a board that anyone else has tested yet with this ota sketch, and if so, what settings for memory (i've always had difficulty with the finer points of memory allocation)
So far, i've managed to upload to the board, i've seen an ip address assigned, but not managed to see the ota port listed. I'm using 1.6.7, i've installed both versions of the board manager profiles for esp, i'm not sure what is the correct configuration here also, should i install the g938.... version first then upgrade? the instructions on git seem to suggest you must have both installed, but i cant see which should be active..
Please, any feedback would be appreciated, it looks like a project with so many possibilities.
Thanks