ESP8266 Community Forum

Middelbh wrote:Thx pipi16,

Will test immediately tomorrow!
Hans

and use two pullup resistor

Perhaps you chaps might like to see my build of this.

I've changed a few things around from the great original code:
The AP strengths are now right hand side justified.
Encryption type is shown, or, a simple '*' to denote no encryption.
It will connect to the home network if found and then display Thingspeak data. That has been useful already while working outside on another project.
A future version is intended to show the time instead...which means we can build atomic watches for under $10 !

https://www.youtube.com/watch?v=_btlh6u-jvU
(5mins 25sec)

Oh and there's now battery code, to display the charge in mV of a connected lipo.
It uses a measured 85mA nearly all the time, just spikes when connecting online.

I was thinking about sleep modes and such, before realising that the On/Off switch is perfectly usable as a battery saver ! any data can be brought up to date with the next online connection.

Hi Slider2732,

Lovely work, nice to see my code example still being used and enhanced, like the drive through lol.

Dans