-->
Page 1 of 1

Did I damage my board?

PostPosted: Tue Apr 12, 2016 3:15 pm
by SunboX
It started to throw some exceptions at me yesterday. So I flashed the firmware today as described here: http://www.allaboutcircuits.com/project ... fi-module/

That worked well (except the Putty part, that won't output the AT command at all).

Than I flashed this small sketch with the Arduino IDE:

Code: Select allvoid setup() {
  Serial.begin(115200);
}

void loop() {
}


Running this sketch, I constantly seeing exceptions like this in the serial console:
Code: Select allException (28):
epc1=0x402015bf epc2=0x00000000 epc3=0x00000000 excvaddr=0x0000001c depc=0x1082b6f6

ctx: sys
sp: 3ffffc00 end: 3fffffb0 offset: 01a0

>>>stack>>>
3ffffda0:  ffffffff ffffffff ffffffff ffffffff 
3ffffdb0:  00000000 ffffffff ffffffff ffffffff 
3ffffdc0:  00000002 00000000 40214ca0 00000000 
3ffffdd0:  00000000 00000000 00000000 00000000 
3ffffde0:  00000000 ffffffff ffffffff ffffffff 
3ffffdf0:  40230640 40214ca0 00000000 00000000 
3ffffe00:  00000000 00000000 00000000 4020889f 
3ffffe10:  00000002 00000000 40214ca0 00000000 
3ffffe20:  00000000 00000000 00000000 40101e6b 
3ffffe30:  40101e4c 3fffc100 3ffe9bac 00000000 
3ffffe40:  00000000 40214ca0 04000000 00000000 
3ffffe50:  400005e1 00000004 40000f49 00000000 
3ffffe60:  40214ca0 00000030 0000001a 4010536a 
3ffffe70:  40214c9d 00000001 00000000 3ffe8e40 
3ffffe80:  00000000 00000001 00000000 7fffffff 
3ffffe90:  00000000 3ffe92d5 3ffe92d0 00000000 
3ffffea0:  3ffe9ba0 3ffe9bac 00000000 00000000 
3ffffeb0:  40202603 004fd514 3ffeea14 3fffd9d0 
3ffffec0:  00000000 00000000 00000000 fffffffe 
3ffffed0:  ffffffff 3fffc6fc 00000001 3ffeea20 
3ffffee0:  00000000 3fffdad0 3ffeea18 00000030 
3ffffef0:  00000000 3fffdad0 3ffeea18 00000030 
3fffff00:  0000001c ffffffff ffffffff 40106418 
3fffff10:  0018d33a 3ffee634 0000001c 40100774 
3fffff20:  3ffefb34 00000014 00000064 40107208 
3fffff30:  0018d33a 3ffee634 3ffefbf4 402288e2 
3fffff40:  40214c84 00000000 3ffe9ba0 3ffe9bac 
3fffff50:  00000000 3ffe9104 3ffe8810 40228a15 
3fffff60:  00000000 40204f35 3ffe8c7c 40214855 
3fffff70:  3ffecd60 3ffe9ba0 3fffdcc0 3ffe9328 
3fffff80:  00000040 3ffecd60 00000000 3ffeea20 
3fffff90:  40214223 3fffdab0 00000000 40202617 
3fffffa0:  3ffe9328 40000f49 3fffdab0 40000f49 
<<<stack<<<

 ets Jan  8 2013,rst cause:1, boot mode:(3,6)

load 0x4010f000, len 1264, room 16
tail 0
chksum 0x42
csum 0x42
~ld


Did I damage the boar somehow? Is there something else wrong? Should I provide more power? (running it from USB currently with a LD1117V33 between)

thanks and greetings,
André