Re: OTA firmware updates
Posted: Tue Nov 21, 2017 1:04 amI think the location of the file system is set in the code somewhere as a define - you may need to change that setting when you build user2.
ESP8266 Community Forum
Open Community Forum for ESP8266, Come share Arduino and IoT (Internet of Things)
https://www.esp8266.com/
OTA firmware updates
Page 4 of 6
Posted: Tue Nov 21, 2017 1:04 amRe: OTA firmware updates
Posted: Tue Nov 21, 2017 4:59 pmI was looking at that, but it looks to me as if that option is not used and the web pages are linked as a library. Which should work OK for user1 and user2. But when I tried to see if it was working I got some odd results including what looked like the running code aways being at the same address even when it had been started by the boot up at different addresses. Am I looking at the wrong things?
Re: OTA firmware updates
Posted: Wed Nov 22, 2017 7:30 pmCheck the following code in user_main.c:
Code: Select all
#ifdef ESPFS_POS
CgiUploadFlashDef uploadParams={
.type=CGIFLASH_TYPE_ESPFS,
.fw1Pos=ESPFS_POS,
.fw2Pos=0,
.fwSize=ESPFS_SIZE,
};
#define INCLUDE_FLASH_FNS
#endif
#ifdef OTA_FLASH_SIZE_K
CgiUploadFlashDef uploadParams={
.type=CGIFLASH_TYPE_FW,
.fw1Pos=0x1000,
.fw2Pos=((OTA_FLASH_SIZE_K*1024)/2)+0x1000,
.fwSize=((OTA_FLASH_SIZE_K*1024)/2)-0x1000,
.tagName=OTA_TAGNAME
};
#define INCLUDE_FLASH_FNS
#endif
Re: OTA firmware updates
Posted: Sat Nov 25, 2017 4:48 pmThanks for pointing to that code, sorry for slow reply I only get to this project occasionally.
It does look wrong, 4096(1024+1024) is loading user2 at 0x101000 not 0x201000 as calculated.
But so far changing it has not helped.
The debug printout on the serial port says
but that does not relate to any address I expect.
I will look further, but if anyone has this working .......
It does look wrong, 4096(1024+1024) is loading user2 at 0x101000 not 0x201000 as calculated.
But so far changing it has not helped.
The debug printout on the serial port says
size = 96mem addr = 1073682136, size = 96DataLen=1024
but that does not relate to any address I expect.
I will look further, but if anyone has this working .......