In ANNEX RDS The WIFI in AP+STA mode can be obtained configuring the module in AP mode and then using the command WIFI.CONNECT in the program.
See Annex RDS version 1.43 or later.
Explore... Chat... Share...
Hi @QuickFix Thank you for your response. I am fin[…]
This is for Compiler Chat! Not sure, but TS co[…]
I noticed that my browser would not load completel[…]
This is a Google Script that retrieves environment[…]
Thanks for sharing. I did something similar a few […]
You can use Raspberry pi instead. You can run a py[…]
As far as I know, ESP8266 RTOS SDK does not have a[…]
It seems like there are a few issues with your cod[…]
There could be a number of reasons why this is hap[…]
Thanks for sharing. Gotta give a try someday.
The code you installed was likely meant for the ES[…]
Yes, there are examples of connecting to an ESP826[…]
Which project, dear? Did you forget to put the pro[…]
Using an ESP8266 to read the duty cycle of the sea[…]
Positioning the ESP-32 on top to dissipate heat is[…]
It sounds like the two Sonoff Basic devices you ar[…]
You can try the solution given here: https://stack[…]
Some similar problems have been discussed in the f[…]