ESP8266 Community Forum

- Fri Nov 13, 2015 11:42 pm #33932 To put the information out to a page you must first get the value from a pin and then spring it to the main page. This is not applicable to the msg URL stuuf as that is a bit different.

Code: Select allbla = 0
Pi 5 bla
Wprint bla
Wait


The pi command will receive the pin status from pin 5 and put it to the web page on run. I have been considering making all of the pin I/o commands acessable in a function for direct assignment but have not done this as of yet.

Serial terminal in the chrome browser see https://serialTerminal.com

http://esp8266basic.com
A BASIC interpreter for your ESP

Working now on Autodrop3d. A 3d printer with automatic part ejection system. https://autodrop3d.com

- Fri Nov 13, 2015 11:56 pm #33933 I did try this actually but I did not specify that bla = 0 first

So you need to first specify that bla is a variable by giving it a value

Then you can use it as a variable thanks this should give me some direction to play with!

Helpful? Donate To help support Mike http://www.esp8266basic.com click the donate button lets keep this project going and hope we can get the ESP32 in the mix. BEGINNERS GUIDE HERE http://www.esp8266.com/viewtopic.php?f=40&t=6732

Where I buy my ESP8266 boards from... (Banggood)