How to use nodemcu tx rx pin seperatly
Posted: Sat Mar 09, 2019 8:16 amHi!
I am using nodemcu with esp8266 basic & creating page works perfectly.
I am sending para from usb to webpage & updating on page.
But when i send data from arduino to rx pin of esp8266 then garbage is receiving.
It seems me rx pin is already connected to usb to serial convertor chip , so data goes incorrect.
can some on have any solution ?
Thanks
Roshani
I am using nodemcu with esp8266 basic & creating page works perfectly.
I am sending para from usb to webpage & updating on page.
But when i send data from arduino to rx pin of esp8266 then garbage is receiving.
It seems me rx pin is already connected to usb to serial convertor chip , so data goes incorrect.
can some on have any solution ?
Thanks
Roshani