ESP8266 Community Forum

hi there,
don´t know what went wrong, but WiFi is not showing up after flashing and resetting the chip.
Flashed according to the Video. 1:1.
Used Com4 and 2M. LED flashed blue during process. 100% completed bubt somehow weird text lines below 100% result.

After that tried to reset several times. Grounded reset, with out GPIO 0 to Ground.
Nothing seems to work. What is my mistake? Any idea here in the comunity? Flashed two Chips, both same result.
Chip is labled: esp8266 esp-01 > ESP8266EX / 252019 / UB00PNRU25.

In case something went wrong? How can I erase flashing result and re-flash from different Computer?
Sorry, newbee with clue but obviously not enough.

Please help. thank you.
BR from Germany
Bibo

I presume you know that after flashing it is in AP mode ???

You have to access it from your telephone or tabet as the ESP is being an
Access Point.
So connect to it and surf to 192.168.4.1

Luc

Thank you.
Clear! But ESP must show up in the available wifi list of phone or tablet. Then I can connect to it and surf to the given ip adress.
This is not the case, unfortunately.