Re: Getting Started Guide
Posted:
Thu Oct 29, 2015 4:41 am
by rich
I am guessing my ESP-01 is a 4m bit board, so 512kb and therefore too small for loading Basic.
Re: Getting Started Guide
Posted:
Thu Oct 29, 2015 6:12 am
by Mmiscool
There are 2 models of the esp-01.
The blue boards have a 512k flash while the black ones have 1mb of flash.
Recent changes have made the binary to big for the 512k modules.
Re: Getting Started Guide
Posted:
Thu Oct 29, 2015 11:10 am
by rich
All OK, found the IP address on the serial port at 9600!
Ignore the rest of this post!
OK so now I have an ESP-12 and once I ditched the 3.3V vcc from the USB Serial and used a proper PSU, I am getting the Basic IDE page up!
Next question, to set the ESP8266 to Station mode instead of AP mode, I just fill out the SSID and password, Save and Update and re-power?
I am still seeing it as an AP device.
Anything else I need to do to get Station mode working?
Cheers,
Rich
Re: Getting Started Guide
Posted:
Fri Oct 30, 2015 7:42 pm
by Mmiscool
So rich. Are you all set. Hows it working for you?