I was wondering if anyone could help me with my ESP8266-1. I'm interfacing with it using a FTDI FT232RL. After connecting, not matter what commands or baud rate I put in, I couldn't get a response from the module. I then went ahead and downloaded the flasher on this site (https://importhack.wordpress.com/2014/1 ... eb-client/). It kept crashing, giving a message about a failed package. Wouldn't get past 10%. I then switched over to nodemcu. Now when I switched over to nodemcu, things started to work a little. I was able to flash the default .bin file although I'm not exactly sure what that does. There is still no response from the module though when I enter AT. Could someone please point me in the right direction? It would be greatly appreciated!
I was wondering if anyone could help me with my ESP8266-1. I'm interfacing with it using a FTDI FT232RL. After connecting, not matter what commands or baud rate I put in, I couldn't get a response from the module. I then went ahead and downloaded the flasher on this site (https://importhack.wordpress.com/2014/1 ... eb-client/). It kept crashing, giving a message about a failed package. Wouldn't get past 10%. I then switched over to nodemcu. Now when I switched over to nodemcu, things started to work a little. I was able to flash the default .bin file although I'm not exactly sure what that does. There is still no response from the module though when I enter AT. Could someone please point me in the right direction? It would be greatly appreciated!