Re: ESP-03 module reset pin
Posted:
Fri Nov 21, 2014 1:27 pmby aterentiev
Yes, thank you. The picture is enough for me to understand. I wonder why the reset is working, because through these pads the reset pin is connected to the gpio16 pad...
Anyway I'll test is too when I have them.
Re: ESP-03 module reset pin
Posted:
Fri Nov 21, 2014 3:25 pmby martinayotte
According to schematic, the pads seems to be the resistor between pin32 and pin 8 of the chip, so, normal behavoir should be that GPIO16 drive the XPD_DCDC and if we wish also to connect it to EXT_RSTB, we need to add this resistor on the pads.
Re: ESP-03 module reset pin
Posted:
Mon Nov 24, 2014 12:47 pmby alonewolfx2
thoose pads connects gpio16 and reset pin. i soldered thoose pin and tried sleep mode and its perfectly working
deepsleep power state is 0.038-0.043 ma mean 38-43 µa on esp-03
Re: ESP-03 module reset pin
Posted:
Tue Dec 02, 2014 3:54 amby ranhaber
alonewolfx2 wrote:thoose pads connects gpio16 and reset pin. i soldered thoose pin and tried sleep mode and its perfectly working
deepsleep power state is 0.038-0.043 ma mean 38-43 µa on esp-03
Do you mean the jumper near VCC and GPIO14?
Did you used a resistor or just a wire?