Re: Review & tips: generic USB ESP-01 programmer (ebay)
Posted: Tue Aug 22, 2017 3:26 pmAnd Finished! roughly about 2 hours of careful micro-surgery & soldering, but I've converted mine into a full-functioning programmer!
A little blurry, But the finished project before gooping it!
super simple, a few parts (momentary contact pushbutton, 2x 10K resistors for pull-up, A jumper header, shorting chip, and a thin piece of wire..
parts, and clearer picture after gooping
the schematic is fairly simple, here a physical parts and schematic.
physical parts, hand-drawn
rebuild2.jpg (15.81 KiB) Viewed 7901 times
schematic with parts borrowed from Fritzing
super simple, a few parts (momentary contact pushbutton, 2x 10K resistors for pull-up, A jumper header, shorting chip, and a thin piece of wire..
the schematic is fairly simple, here a physical parts and schematic.
rebuild2.jpg (15.81 KiB) Viewed 7901 times