ESP8266 Community Forum

hi frans willem I am using jinx seems to work a lot beter and I can use the split frame size to increase my matrix size
works perfectly with the old firmware and all of my pixels work (16x24)

Hi all and specially ledfreak3d, Frans-Willem, Fladdie, sfranzyshen,

first thanks for the great project connecting a LED Strip to Esp8266 and send commands via tpm2net

Are you already working on the projects?

I'm starting to build also some ESP8266-01 to ws2801 strips.
I read the thread but lost a little bit the overview about what fits best to my needs?

Best should be ESP as Client connecting to my router with configurations on the ESP via website
I want to send the tpm2net data from Raspberry Pi/Hyperion to the ESP8266, but the RPi is connected via LAN to my Router/Network in 192.168.0.* range. So Client mode is best for the ESP, or?

1. I think I can use the "old" fw from sfranzyshen. This is ESP with AP and IP 192.168.4.1.
I have problems build a build env.
Can someone post a precompiled fw with IP 192.168.0.2 and one with 192.168.0.3

2. Should the Frans-Willem v02 fit my needs with ws2801?

3. What is the best fw/solution at the moment for my needs with ws2801? See above.

I will return results here for the ws2801 tests.

P.s. I will try also to build a build env by this is not so simple for me

Thanks you very much!

Hi all! I have the same problem. Want to use several ESP8266-that-be to connect more than 512 diodes... Tell me, what can I do? For earlier thanks!!!