ESP8266 Community Forum

Good advice quackmore. I was just getting again started tonight after a break BUT I left my multimeter on and the battery is flat. While trying to remove the connector from the battery one of the terminals on the connector has ripped out

Well a bit of progress. With my standby multimeter; I confirmed the SD card pin was correct and I still get "Can not initialise the card". I then remembered taking the card out and putting it back could make it work and it does. So I just need to sort out why this has started happening again after it worked for a couple of weeks without a problem.

An update and feeling a bit calmer

SD card was corrupted - but no idea what caused the corruption and it contained some data. I am wondering if something happened when my wife was jogging. Previous tests had been at walking pace. The SD card adaptor and GPS are only supported by the pins on one end. I suppose I could try a shake test.

Interrupt button still not working.