Page 2 of 2

Re: Using an ESP in AP mode to control a blinking LED

PostPosted: Tue Nov 19, 2019 12:27 pm
by Sam G
That's a nice solution. I was looking at ways to increase the delay between blinks while keeping the length of them the time on the same, but all but one of the examples I found used delays. I did find this, though: https://gist.github.com/justinledwards/8139051#file-8ledblinkwodelay-ino
I'm having trouble figuring out how it works. Would it be possible to modify it so that instead of using a random interval, I can set it to a specific number? Does this allow you to set the the amount of time the LED spends on separately from the time off?