cannot use nodemcu -ua or micropython after arduino IDE
Posted: Wed Nov 27, 2019 2:52 am
Hello,
I'm using wemos D1 mini from years, usually with nodemcu lua firmware. I got strange problem when I use arduino IDE on that board to write/test something it work fine, after that if try to flash MicroPython or Nodemcu it flash well, but not power up. Led start blinking without end, serial monitor drop garbage on screen.
If flash with arduino IDE again, it work with it.
Board is kind-a bricked/locked with arduino IDE code upload now I got 2 boards like this. Any idea how to fix it?
I'm using wemos D1 mini from years, usually with nodemcu lua firmware. I got strange problem when I use arduino IDE on that board to write/test something it work fine, after that if try to flash MicroPython or Nodemcu it flash well, but not power up. Led start blinking without end, serial monitor drop garbage on screen.
If flash with arduino IDE again, it work with it.
Board is kind-a bricked/locked with arduino IDE code upload now I got 2 boards like this. Any idea how to fix it?