- Mon Nov 16, 2020 8:50 pm
#89481
When I start a TCP server via AT+CIPSERVER, how do I know which interface does it listen on when the chip is running in dual mode AP+Station? When in the SoftAP mode I can connect to 192.168.4.1. But when I also enable the station mode and the chip connects to the router, the server is only accessible via 192.168.0.x which is my router's DHCP range. Does the sequence matter, say enable the AP mode, then start a server then enable the AP+station mode?
It takes about 20-25 seconds for home assistant c[…]
I tried to upgrade tof my sonoff basic R2 with the[…]
a problem Perhaps you want to define "Probl[…]
Rebooting your router will not give you a faster I[…]
There are no other notifications from esptool.py i[…]
Using the Arduino IDE, you'll learn how to set up […]
In this project, you will post to Twitter using an[…]
In this project, we will build a water level contr[…]
I guess I'm late, but I had the same problem and f[…]
Last night I received my first D1 Minis for a lear[…]
Although I am aware that this is an old post, I fe[…]