ESP8266 Community Forum

Posted: **Fri Nov 04, 2022 4:24 am**

If you use the AT+CIPSEND command, nothing can be returned after SEND OK is output.

ㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡ
AT+CIPSTART="TCP","172.30.1.51",80

CONNECT

OK
AT+CIPSEND=63

OK
>

busy s...

Recv 63 bytes

SEND OK
CLOSED
ㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡㅡ

Help me..

Posted: **Sat Nov 05, 2022 4:04 am**

so what is the output if you use 65?

Posted: **Sun Nov 06, 2022 1:37 am**

The same problem had been discussed here: https://forum.arduino.cc/t/at-cmd-cipse ... /908279/14
Don't know if the problem was solved. But you may get a little bit of clue.

ESP8266 Community Forum

AT+CIPSEND, nothing can be returned after SEND OK is output.

AT+CIPSEND, nothing can be returned after SEND OK is output.

Re: AT+CIPSEND, nothing can be returned after SEND OK is out

Re: AT+CIPSEND, nothing can be returned after SEND OK is out