-->
Page 1 of 7

Flashing fw stops after 20 seconds

PostPosted: Tue Apr 28, 2015 4:55 pm
by Mr.Morse
The ESP-01 that I have doesn't seem to like to be flashed for more than 20 seconds as it goes in timeout. Can't flash nodeMCU on any of the three esp-01 I have, all of them are behaving the same.
So far nodemcu flasher stops after 20 seconds.
Trying to revert back to original FW is not working;
Using esp8266_flasher.exe and various .bin files and I always get "Invalid head of packet" error.
XTCOM_UTIL stops during user1.bin at about 33732 B.
espressif's FLASH_DOWNLOAD_TOOLS_v0.9.5 also gives me "Invalid head of packet" error.
Also tested with with different power supplies for the 3.3v
I've tested the ftd232r with putty (jumper from tx to rx) and it works fine.
Yes, they did work before (checked with coolterm)

At this point I'm suspecting PEBKAC... :oops: :oops:

WTH am I doing wrong?

Re: Flashing fw stops after 20 seconds

PostPosted: Wed Apr 29, 2015 6:34 am
by Mr.Morse
Tried flashing in a linux system (ubuntu) following this guide and the latest firmware from here.

Still stops at 7%. #¤%#%&#¤%&"!!! :evil: :evil: :evil: :

BTW is it possible to use an arduino mega as FTDI and go through that to rule out my FT232R?

Re: Flashing fw stops after 20 seconds

PostPosted: Wed Apr 29, 2015 11:40 am
by MeNoGeek
No. Arduino Mega GPIOs and UARTs output 5V signals. If you want to rule out your FT232R, find a cheap USB to 3.3V TTL converter.

Re: Flashing fw stops after 20 seconds

PostPosted: Wed Apr 29, 2015 1:08 pm
by marin6061
Hi,
I have exactly the same problem with 2 sets, first set ESP-01 + usb to serial based on FT232R chip,
first I thought something wrong with this set, so I ordered another set from a different seller, but got exactly the same result