Re: Boot message: MEM CHECK FAIL!!!
Posted: Mon Jun 08, 2015 1:25 am
Cal, you beat me to it I was just about to post the results of my findings. Ok, here's what I did:
1. To an otherwise virgin AT firmware from the 1.1.0 SDK I added the following as the first thing in user_init()
2. Rebuilt and flashed the new AT binary.
3. Made sure wifi config region of the flash (0x7e000-0x7ffff) was empty of SSID/pass
4. Joined an AP with AT commands
5. Read the wifi config region again.
RESULT: Sure enough, it saves the SSID/pass combo there
1. To an otherwise virgin AT firmware from the 1.1.0 SDK I added the following as the first thing in user_init()
Code: Select all
wifi_station_set_auto_connect(0)
2. Rebuilt and flashed the new AT binary.
3. Made sure wifi config region of the flash (0x7e000-0x7ffff) was empty of SSID/pass
4. Joined an AP with AT commands
5. Read the wifi config region again.
RESULT: Sure enough, it saves the SSID/pass combo there