ESP8266 Community Forum

- Thu Aug 20, 2015 6:28 am #26554 hi!
I turned on the chip correctly 3.3v, tx, rx and gnd
i can see SSID of the chip in my computer
but when I try the AT command responds error

- Fri Aug 21, 2015 8:59 am #26694 help

- Fri Aug 21, 2015 9:18 am #26696 Have you tried entering AT commands at this point? What happens?

Free ESP8266 book available for download here.

- Fri Aug 21, 2015 9:30 am #26698 Hi, looking at the screen shot of your terminal, your only using new line. For what you are trying to do your need new line & carrage return (NL CR). Set this next to the baud rate. A picture is worth a thousand words.

Last edited by Barnabybear on Sat Aug 22, 2015 2:58 am, edited 1 time in total.