ESP8266 Community Forum

Posted: **Mon Dec 01, 2014 9:38 pm**

elac wrote:Is AT+CIOBAUD not working in this new firmware?
I can't seem to change it from the default 115200 it set to after flashing.

The new command to change baudrate is AT+IPR, but AT+IPR? and AT+IPR=? are not implemented.

Posted: **Mon Dec 01, 2014 9:48 pm**

Thank you much garyservin.
Could you tell me where you found that command?

Posted: **Mon Dec 01, 2014 10:04 pm**

You're welcome! I found it digging through the source code

Posted: **Tue Dec 02, 2014 6:49 am**

Thanks again garyservin!

News! AT_v0.20 released!