Re: ai-thinker iot app doesn't run
Posted: Tue Dec 04, 2018 5:37 am
schufti wrote:a) hopefully you not only connected tx and rx but gnd also.
b) maybe there is a problem with the procedure:
1) connect usb-serial converter
2) set jumper
3) reset or alternatively power on board
4) start flashing
5) remove jumper
6) reset or power off/on board
this should get you going.
depending on the us-serial converter it might be necessary to
a) remove rx/tx before 6)
b) cross over rx/tx
I'll try asap hoping you advice were useful
Thank you!