- Sat Jan 23, 2016 9:26 am
#39488
You might should have put this post up in one of the categories as I'm not sure everyone checks down here
Have you connected a serial terminal to the same com port that you use to flash the OS into the module with??
You will get quite a bit of feedback from the module as you boot up, etc.
When you try to save code to the module you will get feedback on the serial port as each line is saved to the module.
you might also go back to an earlier version of the OS to see if the problem goes away.
Also try and do a code save right after a reboot.
I learned a while ago to save a copy of my code by copy/paste to a notepad document and not rely on just the code saved in the module.
dwight