P.S I found these power supplies and im going to test them out so i can plug this in to the wall and make enclosure for it.
http://www.ebay.com/itm/400761809788?_trksid=p2059210.m2749.l2649&var=670305530456&ssPageName=STRK%3AMEBIDX%3AIT
Explore... Chat... Share...
hansaya wrote:Did anyone ran the chip for long period of time? I noticed the chip randomly holds on deepsleep mode after few days. This happened two times now and idk why. When i reset the chip using RST pin it works again. . I use the 400ohm resistor between GPIO16 and RST, 400ohm could be too big and i might have to lower it down to 200. Let me know if anyone experience the same issue.
P.S I found these power supplies and im going to test them out so i can plug this in to the wall and make enclosure for it.
http://www.ebay.com/itm/400761809788?_trksid=p2059210.m2749.l2649&var=670305530456&ssPageName=STRK%3AMEBIDX%3AIT
alonewolfx2 wrote:hansaya wrote:Did anyone ran the chip for long period of time? I noticed the chip randomly holds on deepsleep mode after few days. This happened two times now and idk why. When i reset the chip using RST pin it works again. . I use the 400ohm resistor between GPIO16 and RST, 400ohm could be too big and i might have to lower it down to 200. Let me know if anyone experience the same issue.
P.S I found these power supplies and im going to test them out so i can plug this in to the wall and make enclosure for it.
http://www.ebay.com/itm/400761809788?_trksid=p2059210.m2749.l2649&var=670305530456&ssPageName=STRK%3AMEBIDX%3AIT
i am using 0 ohm resistor and i tested 5 days and its working well.
It takes about 20-25 seconds for home assistant c[…]
I tried to upgrade tof my sonoff basic R2 with the[…]
a problem Perhaps you want to define "Probl[…]
Rebooting your router will not give you a faster I[…]
There are no other notifications from esptool.py i[…]
Using the Arduino IDE, you'll learn how to set up […]
In this project, you will post to Twitter using an[…]
In this project, we will build a water level contr[…]
I guess I'm late, but I had the same problem and f[…]
Last night I received my first D1 Minis for a lear[…]
Although I am aware that this is an old post, I fe[…]