Is any way to do that no high output for IO0 at startup?
Explore... Chat... Share...
donsergio wrote:Is any way to do that no high output for IO0 at startup?
GPIOs 4 and 5 are the only ones that are always high impedance. All others do have internal pull-ups or are even driven low/high during boot.
GPIOs 3, 12, 13 and 14 pulled HIGH during boot. Their actual state does not influence the boot process.
GPIOs 0, 1, 2 and 15 are pulled HIGH during boot and also driven LOW for short periods.
The device will not boot if 0, 1 or 2 is driven LOW during start-up.
GPIO 16 is driven HIGH during boot, don't short to GND.
Hi Ken, thank you very much for your Hints! I did […]
Hello, My project is downright simple : create an[…]
I’m new to coding,and i do have issues in combinin[…]
Hi, I'm trying to get OTA working with the Mini ([…]
Hello :D I am currently having the same issue o[…]
Hello everyone, I found on the internet a Block t[…]
Hi, I want help to select the best way to achieve[…]
Thanks for documenting this, will be useful in the[…]
Any luck getting this to work? I am working on a s[…]
I am trying to get my ESP-01 to go into deep sleep[…]
Hi, I am updating our custom ESP8266 firmware (ba[…]
Hi all i am new to esp8266 and need help i am try[…]
hi, the code is taken for testing from the doc in […]
Hey, everybody, I don't know if this is the right […]
IoT Manager reborn - release v2.0 :D https://pla[…]
How to solve this problem? I have esp8266 module ([…]
Hi everybody, I'm a new member and I am a newbie o[…]
Hi! I've got hold of an oracle code card (schemati[…]
It's good to discuss our every problem here and g[…]