Your new topic does not fit any of the above??? Check first. Then post here. Thanks.

Moderator: igrr

User avatar
By hassan1551
#88259 When I first started working with the ESP8266 Wemos D1 Mini, it was just working fine. Suddenly, it started to act very weirdly. It does not run the application and every time I restart it, it shows some weird messages on the Serial Monitor. When it first started, I got this message:

"ets Jan 8 2013,rst cause:4, boot mode:(3,6) wdt reset load 0x4010f000, len 3664, room 16 tail 0 chksum 0xee csum 0xee v39c79d9b ~ld"

Today, I got something that is not understandable, keep in mind that I know that I have to put "Serial.begin()" and set the serial monitor with the same Serial speed on the sketch. To program it, I chose "LOLIN(WEMOS) D1 R2 & mini" board from the tools menu. And the rest of the options are the same. This is the board that I have:,searchweb201602_,searchweb201603_