I'm designing a PCB where I want ESP run in normal mode, but I can connect through header to program ESP please refer to images.
Please look at my schematic U10 is programming header, I will connect it to ESP-01 header (please refer to image)
Explore... Chat... Share...
Moderator: igrr
sairfan06 wrote:I'm using ESP12E and i believe i have to pull up GPIO 2 and pull down GPIO 15, is that right?
if you pull down GPIO15 with 10k resistor for boot, then in the program (after boot) can i send signal with state HIGH
It takes about 20-25 seconds for home assistant c[…]
I tried to upgrade tof my sonoff basic R2 with the[…]
a problem Perhaps you want to define "Probl[…]
Rebooting your router will not give you a faster I[…]
There are no other notifications from esptool.py i[…]
Using the Arduino IDE, you'll learn how to set up […]
In this project, you will post to Twitter using an[…]
In this project, we will build a water level contr[…]
I guess I'm late, but I had the same problem and f[…]
Last night I received my first D1 Minis for a lear[…]
Although I am aware that this is an old post, I fe[…]