- Tue Feb 16, 2021 12:38 pm
#90547
Moved it to the hardware section.
You'll experience this if you did not sufficiently decouple the RESET and ENABLE lines. They're susceptible to noise and can cause a chip reset. I recommend pulling them up using 10 k resistors and in addition to that, add a decoupling capacitor of 100 nf to both RESET and ENABLE lines. This will work most of the time.
You'll experience this if you did not sufficiently decouple the RESET and ENABLE lines. They're susceptible to noise and can cause a chip reset. I recommend pulling them up using 10 k resistors and in addition to that, add a decoupling capacitor of 100 nf to both RESET and ENABLE lines. This will work most of the time.
