ESP8266 Community Forum

- Sun Sep 17, 2017 5:37 am #70049 I am searching for a solution to program my Arduino Mega 2560 from remote over internet/ethernet and use the existing USB programming interface.

I have read about this project but have a question about the use.

Is it possible to use this Virtual USB driver for ESP8266 to program an 2560 where ESP8266 will be the transparent wifi / ethernet to usb bridge?

regards

Kjartan Iversen

- Mon Sep 18, 2017 8:45 am #70079 Take a look at ESP-LINK :
https://github.com/jeelabs/esp-link

- Thu Aug 02, 2018 8:53 am #77541 Hi there! I know this is kinda off topic but I was wondering which blog platform are you using for this site?

I’m getting fed up of WordPress because I’ve had problems with hackers and I’m looking at alternatives
for another platform. I would be awesome if you could point me in the direction of
a good platform.

https://telectronics.pk/all-under-999

- Fri Aug 03, 2018 2:15 am #77560

I was wondering which blog platform are you using for this site?

If you look closely at the bottom of each page, you'll find a link to SiteSplat.

BTW. As a site owner (I also run a couple of domains and forums myself), you're always victim of hacking attempts, no matter what platform you use.

Assumption is the mother of all f*ckups; I should know: I've been assuming a lot.
When you're new, don't start with a separate ESP (ESP-01 to ESP-14) module.
Get yourself a proper development board: NodeMCU - WeMos D1 - Witty Board - ESP Thumbdrive
ESP power requirements are 3.3V±10%@500mA
The ESP8266 IS NOT 5V tolerant on ANY pin (see item 5.14 on page 25 of the FAQ)