The one version is with time() and configTime(), the other uses the sntp_ calls.
Both seem to forget about the timezone after a while. At first the clock is right, a couple of hours later the device seems to think it's in London.
Any clues ?
Explore... Chat... Share...
You need a supply that is capable of at least 300m[…]
On board connection for deep sleep via resistor wi[…]
First, Thanks for the response.I note that the ex[…]
Both hardware and software watchdogs are there to […]
I put a ZIP-archive under http://www.wunderwald.c[…]
NodeMCU D1 Mini boards, I know of NodeMCU V1/2/[…]
Hi there, I'm trying to adopt the sketch bellow t[…]
I've created a simple Internet synchronized clock […]
The trick is remembering that Lua is interpreted, […]
I've put an instructable up describing a esp-12 ba[…]
Moved block of code responsible for every 15 minut[…]
if you look at the 10min and 1h value, you'll see […]
These modules normally have an internal pull up re[…]
The hardware actually seems to be identical, at le[…]
Rename or delete the C:\Users\admin\Documents\Ardu[…]
Hello, I am using esp-open-rtos and I am communi[…]
Thanks to all for replying! This is due to the f[…]
And you are sure you were able to configure the ti[…]
Just philosophising here (I wrote something simila[…]