A converter does not give enough intensity with
I succeeded with
But the controls are reversed (not serious) and when the engine stops through R2 28 mA and when running is 4mA.
How to reverse so that at rest we have a weak current ?
Explore... Chat... Share...
rudy wrote:If you are only trying to provide an input to the VNH2SP30 then you don't need to use 200 Ohms. Change the resistor to 2K2, or something at that level.
140 messages / day is for sigfox iirc. haven't rea[…]
Hello everyone. I'm using ESP8266 NodeMCU LUA CP2[…]
From what you posted, it looks like you are using […]
Update: It seems the serial communication works i[…]
Thanks. I tried it but didn't work. I think I prob[…]
Hi, Try to change the CS pin to another. Instea[…]
that is not related to the hardware but to a faul[…]
I don't see anything wrong in how you are going ab[…]
Hello! Is my first first time i want to make somet[…]
I 'm using an FTDI usb cable trying to program an […]
BTW there is a mode where the pwm duty cycle alter[…]
I am working on the OTA UPDATE of ESP8266 using h[…]
Hello, Your IDE seems the tool I need but ... .[…]
i have searched on the internet and didn't find wh[…]
Hi, Does Node mcu wifi module has any SDIO[…]
Hi, I have a small doubt regarding SDIO pins on th[…]
Thanks, that's really helpful...
Hi all, Not strictly ESP8266 related, but here go[…]
BlitzWolf SHP6 is a ESP8266 based yet another smar[…]
I want to make a device to check that a long case […]