What could be wrong? do i really need to flash these three files on the module? is there a single file with the firmware to flash on the module?
PS: i'm using esptool running on OS X to flash the module.
Thanks for your time.
Explore... Chat... Share...
sudo python esptool.py --baud 921600 --port /dev/tty.usbserial-A700fbUH write_flash -fm dio 0x000000 v188.8.131.52\ AT\ Firmware.bin
Running Cesanta flasher stub...
Flash params set to 0x0200
Writing 1044480 @ 0x0... 1044480 (100 %)
Wrote 1044480 bytes at 0x0 in 15.4 seconds (542.6 kbit/s)...
this C++ types exist more then 50 years. So it sho[…]
Using the MAC address is indeed a useful method pa[…]
It is true the D1 mini like other similar boards w[…]
Hello everyone, I recently got an nodemcu ESP8266 […]
You are going to hate me, but I cannot properly di[…]
I would try out the sketch I indicated as I found […]
Gooday! I may ask to everyone, if it is possible t[…]
I think this guide will help you... https://www.el[…]
Hello everyone, I try to keep it as short as poss[…]
Hi experts! I am working on a small sketch to peri[…]
PS - also be carefull not to do TOO much inside th[…]
Yeah indeed. Wow it's cheap, let's used it EVERYT[…]
Google ESPAsyncWebserver I'm pretty sure it does e[…]
I had similar problems (even the intermitent failu[…]
The thing is, the issue appears beyond the point o[…]
So you got 4 node mcu's all with the same software[…]
I also had to disable the proxy/VPN.
Hi there, tried to Flash a esp8266 esp-01 (exact N[…]
Took me some time to figure it out. Here you go: […]
i think maybe you need to use a different driver f[…]