mode_changes
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
mode_changes [2015/06/24 10:19] tytower |
mode_changes [2015/06/24 10:23] tytower |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ^ MODE ^GPIO15 ^GPIO0 ^GPIO2 | | ^ MODE ^GPIO15 ^GPIO0 ^GPIO2 | | ||
| ^SDIO | 1 | x | x | | ^SDIO | 1 | x | x | | ||
| - | ^UART | 0 | 0 | 1 | | + | ^UART | 0 | 0 | x or 1 | |
| - | ^FLASH (DEFAULT) | 0 | 0 | x or 1 | | + | ^FLASH (DEFAULT) | 0 | 1 | x or 1 | |
| 1=High ,0=Low,x=floating | 1=High ,0=Low,x=floating | ||
| - | Once you have flashed your program on in Flash mode take the low off the GPIO0 and reboot to run your program properly. \\ | + | Once you have flashed your program on in Flash mode, take the low off the GPIO0 and reboot ,to run your program properly. \\ |
mode_changes.txt · Last modified: 2015/08/08 16:39 by admin