This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
connect_to_esp8266_only_using_arduino_uno [2014/12/31 18:19] en10 |
connect_to_esp8266_only_using_arduino_uno [2014/12/31 18:23] en10 |
||
---|---|---|---|
Line 20: | Line 20: | ||
I loaded the BareMinimum sketch, so that no previous sketch causes issues. | I loaded the BareMinimum sketch, so that no previous sketch causes issues. | ||
+ | ---- | ||
- | Once Connected open the Serial Monitor and set Baud to 9600. | + | Once Connected open the Serial Monitor and set "Both NL & CR" and Baud to 9600. |
Send "AT" to test. If nothing comes up try different baud rates such as 115200 or 57600 and retest. | Send "AT" to test. If nothing comes up try different baud rates such as 115200 or 57600 and retest. | ||
Line 27: | Line 28: | ||
If you get "OK" reply then all is working. | If you get "OK" reply then all is working. | ||
+ | ---- | ||
List of commands can be found here: | List of commands can be found here: |