ESP8266 Support WIKI

User Tools

Site Tools


esp8266-test-boards

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
esp8266-test-boards [2015/08/08 16:40]
admin
esp8266-test-boards [2016/05/25 08:25]
livetelevision [AI-Thinker 'Test Board']
Line 15: Line 15:
 ==== Olimex ESP8266-EVB EValuation Board ==== ==== Olimex ESP8266-EVB EValuation Board ====
 ESP8266-EVB is Evaluation board for ESP8266 with relay, button, UEXT, all GPIOs available on 0.1" header ESP8266-EVB is Evaluation board for ESP8266 with relay, button, UEXT, all GPIOs available on 0.1" header
-[[https://​www.olimex.com/​Products/​Modules/​Ethernet/​ESP8266-EVB/​open-source-hardware]]+[[https://​www.olimex.com/​Products/​IoT/​ESP8266-EVB/​]]
  
 ==== AI-Thinker 'Test Board' ==== ==== AI-Thinker 'Test Board' ====
-The AI-Thinker board is an evaluation board with an onboard STC15L204EA microcontroller along with a relay, buttons and LEDs on all GPIOs, a relay, a buzzer, LDR, a socket for NRF240 modules, CH340 USB to Serial converter ​ and DIP switches allowing different IO routing configurations to be setup. ​ A small adapter board connects the normal ESP8266 modules to a pair of 2x4 headers. The board is widely available from a number of Chinese vendors.+The AI-Thinker board is an evaluation board with an onboard STC15L204EA microcontroller along with a relay, buttons and LEDs on all GPIOs, a relay, a buzzer, LDR, a socket for NRF240 modules, CH340 USB to Serial converter ​ and DIP switches allowing different IO routing configurations to be setup. ​ A small adapter board connects the normal ESP8266 modules to a pair of 2x4 headers. The board is widely available from a number of Chinese vendors, sometimes called a Coexistence Module. This is not the cheaper AI-Thinker "​yellow board" (which should have its own entry on this page)
  
 === DIP Switches === === DIP Switches ===
Line 41: Line 41:
 This is the right-most switch when the USB port is at top.  Controls routing of some of the IO and signal lines. This is the right-most switch when the USB port is at top.  Controls routing of some of the IO and signal lines.
  
-| **No.** | **Label** ​   | **Function** ​                               +| **No.** | **Label** ​   | **Function** ​                                    ​
-| 1       | GPIO14 ​      ​| ​?                                           +| 1       | GPIO14 ​      ​| ​ON=AC relay controlled by ESP8266 GPIO14 ​        
-| 2       | DL_MCU ​      ​| ​?                                           +| 2       | DL_MCU ​      ​| ​ON=AC relay controlled by MCU                    ​
-| 3       | CH_PD_H ​     | ON=Enable pull up on CH_PD line of ESP8266. | +| 3       | CH_PD_H ​     | ON=Enable pull up on CH_PD line of ESP8266. ​     
-| 4       ​| ​GPIO0_H ​     ​| ​?                                           +| 4       ​| ​GPIO0_L ​     ​| ​ON=Pull ESP8266 GPIO1 down for flashing. ​        
-| 5       ​| ​GPIO15_H ​    | ?                                           +| 5       ​| ​GPIO15_L ​    | ON=Pull ESP8266 GPIO15 down (normal during boot) 
-| 6       ​| ​GPIO2_H ​     | ?                                           ​+| 6       ​| ​GPIO2_L ​     ​| ​ON=Pull ESP8266 GPIO2 down for                | 
- + 
 +===Relay=== 
 +Normally open, it can bridge the two AC terminal connections together. ​ See above for control. ​ High level closes the relay. ​ Handles 3 amps at 35v DC or 3 amps at 250v AC. 
 + 
 +===Buzzer=== 
 +Annoying. ​ Apparently controlled only by MCU? 
 + 
 +===CDS Light Sensor=== 
 +One is installed on the board, connected to the MCU.  Holes for another wired to the ESP8266 ADC are in place but not populated with a sensor presumably because this version breaks out the ADC for independent use. 
 + 
 +===Schematic=== 
 +What is apparently an older version may be found in [[http://​www.esp8266.com/​viewtopic.php?​f=13&​t=480|this thread.]] 
esp8266-test-boards.txt · Last modified: 2016/06/16 15:55 by livetelevision