This shows you the differences between two versions of the page.
Next revision | Previous revision Last revision Both sides next revision | ||
espduino [2015/01/07 13:38] tuanpm created |
espduino [2015/01/09 06:26] admin |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== espduino ====== | ====== espduino ====== | ||
- | + | This is MQTT client for arduino connect to broker via ESP8266 AT command, port from [[https://github.com/esar/contiki-mqtt|MQTT client library for Contiki]] | |
- | This is MQTT client for arduino connect to broker via ESP8266 AT command, port from [[MQTT client library for Contiki|https://github.com/esar/contiki-mqtt]] | + | |
You can find the Native MQTT client library for ESP8266 work well here: [[esp_mqtt]] | You can find the Native MQTT client library for ESP8266 work well here: [[esp_mqtt]] | ||
Line 8: | Line 7: | ||
* Support subscribing, publishing, authentication, will messages, keep alive pings and all 3 QoS levels (it should be a fully functional client). | * Support subscribing, publishing, authentication, will messages, keep alive pings and all 3 QoS levels (it should be a fully functional client). | ||
* Easy to setup and use | * Easy to setup and use | ||
+ | ====== Required ====== | ||
+ | You will need V0.2 AT+ commands from Espressif, if you do not have you can download and flash the following: ESP8266 At Command 0.2: [[https://github.com/espressif/esp8266_at|https://github.com/espressif/esp8266_at]] | ||
+ | |||
+ | You will also need the ESPDUINO library for Arduino that can be found here: https://github.com/tuanpmt/espduino | ||
====== Warning ====== | ====== Warning ====== |