ESP8266 Support WIKI

User Tools

Site Tools


loading_firmware

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
loading_firmware [2017/01/20 09:42]
flywire [Firmware]
loading_firmware [2018/03/24 09:42]
jpascher [Prerequisites]
Line 3: Line 3:
  
 ===== Firmware ===== ===== Firmware =====
 +
 +A lot of people will prefer now to use [[start-with-esp-12-arduino|Arduino IDE]] for this.
 +Alternatively you may use: 
  
  
Line 16: Line 19:
 ===== Prerequisites ===== ===== Prerequisites =====
  
-To flash the ESP8266, you'll need first need to wire things up. See [[getting-started-with-the-esp8266#​got_an_esp-nn_board_in_the_mail_now_what|Getting Started ​with ESP8266]] for the basics.+To flash the ESP8266, you'll need first need to wire things up. See [[start-with-esp-12-arduino|start-with-esp-12-arduino -> Hardware]] for the basics.
  
 Connect GPIO 0 to ground and reboot the ESP8266 to enter flashing mode. Connect GPIO 0 to ground and reboot the ESP8266 to enter flashing mode.
 +
 +===== Arduino IDE =====
 +Arduino now offer a third party plugin to use the Arduino IDE for different CPUs. 
 +See step by step instructions in [[getting-started-with-the-esp8266#​got_an_esp-nn_board_in_the_mail_now_what|Start with the ESP-12E and the Arduino tools]]
  
  
loading_firmware.txt · Last modified: 2018/03/24 09:43 by jpascher