This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
loading_firmware [2018/03/24 09:37] jpascher [Prerequisites] |
loading_firmware [2018/03/24 09:43] (current) jpascher [Arduino IDE] |
||
---|---|---|---|
Line 19: | Line 19: | ||
===== Prerequisites ===== | ===== Prerequisites ===== | ||
- | To flash the ESP8266, you'll need first need to wire things up. See [[Start with the ESP-12E and the Arduino tools]] -> Hardware for the basics. | + | To flash the ESP8266, you'll need first need to wire things up. See [[start-with-esp-12-arduino|start-with-esp-12-arduino -> Hardware]] for the basics. |
Connect GPIO 0 to ground and reboot the ESP8266 to enter flashing mode. | Connect GPIO 0 to ground and reboot the ESP8266 to enter flashing mode. | ||
Line 25: | Line 25: | ||
===== Arduino IDE ===== | ===== Arduino IDE ===== | ||
Arduino now offer a third party plugin to use the Arduino IDE for different CPUs. | Arduino now offer a third party plugin to use the Arduino IDE for different CPUs. | ||
- | See step by step instructions in [[getting-started-with-the-esp8266#got_an_esp-nn_board_in_the_mail_now_what|Start with the ESP-12E and the Arduino tools]] | + | See step by step instructions in [[start-with-esp-12-arduino|Start with the ESP-12E and the Arduino tools]] |