ESP8266 Support WIKI

User Tools

Site Tools


mode_changes

**This is an old revision of the document!**

Table of Contents


Mode Change

before boot the following wires can be set to give one of 3 modes of operation.

MODE GPIO15 GPIO0 GPIO2
SDIO 1 x x
UART 0 0 1
FLASH (DEFAULT) 0 0 x

1=High ,0=Low,x=floating
Once you have flashed your program on in Flash mode take the low off the GPIO0 and reboot to run your program properly

mode_changes.1434924610.txt.gz · Last modified: 2015/06/21 22:10 by tytower