mode_changes
**This is an old revision of the document!**
Table of Contents
Mode Change
before boot the following wires can be set to give one of 3 modes of operation.
| MODE | GPIO15 | GPIO0 | GPIO2 |
|---|---|---|---|
| SDIO | 1 | x | x |
| UART | 0 | 0 | 1 |
| FLASH (DEFAULT) | 0 | 0 | x |
1=High ,0=Low,x=floating
Once you have flashed your program on in Flash mode take the low off the GPIO0 and reboot to run your program properly
Editor: What do the modes mean? What is SDIO and what is Flash?
mode_changes.1434991300.txt.gz · Last modified: 2015/06/22 16:41 by kolban