This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
nodemcu [2015/04/01 17:31] vowstar Fix format. |
nodemcu [2015/06/21 22:36] terrye [NodeMCU] fix link to correct dokuwiki format |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== NodeMCU ====== | ====== NodeMCU ====== | ||
+ | |||
+ | * See the [[nodemcu-unofficial-faq|nodeMCU Unofficial FAQ]] for answers to your "Frequently Asked Questions". | ||
+ | |||
+ | ===== Hardware ===== | ||
+ | NodeMCU devkit is a development kit for NodeMCU firmware.\\ It will make NodeMCU more easy. With a micro USB cable, you can connect NodeMCU devkit to your laptop and flash it without any trouble, just like Arduino.\\ It is an open hardware, with ESP-12 core with 32Mbits(4MBytes) flash. | ||
+ | |||
+ | ==== Devkit 0.8 ==== | ||
+ | It is the original design of NodeMCU devkit. Very old and never sell on shop. It can't automatic flash firmware. | ||
+ | |||
+ | {{:devkit_0.8.jpg?600|}} | ||
+ | |||
+ | ==== Devkit 0.9 ==== | ||
+ | It is the second design of NodeMCU devkit. It uses CH340G as UART bridge, and can flash firmware automatically by using nodemcu-flasher. | ||
+ | |||
+ | {{:devkit_0.9.jpg?300|}} | ||
+ | {{:devkit_0.9_B.jpg?300|}} | ||
+ | |||
+ | ==== Devkit 1.0 ==== | ||
+ | It is the 5th design of NodeMCU devkit. It uses CP2102 as UART bridge, and can flash firmware automatically by using nodemcu-flasher. It support apple's MAC OS. | ||
+ | |||
+ | {{:devkit_1.0.jpg?600|}} | ||
===== Introduction ===== | ===== Introduction ===== |