i tried these 2 method with modules...they are attached with the post.
can anyone give me some info to make to work or direct me to a post that can help me ???
i tried it powering up from my arduino uno 3.3v output.some websites say that it cant provide enough current.
also i have a AC to DC adapter that can change output voltage and support maximum current of 1A.i tried with it's 3v output.when i connect it to esp it gets really hot.what is i'm doing wrong here ??? how can i use it to power up my esp modules ?
when i connect esp 12 it's blue light on but nothing happens.i used ch340g with jumper on 3.3v and vcc.i also installed it's drivers and got correct com port (com4).i tried with arduino serial monitor.i also tried GPIO 2 and 0 unplugged.
for esp 201 it gives some unreadable output.i tried with different rates (9600 and others) but it didn't change.
yes it is lots of questions..
i tried google,few instructables but nothing.Guys little help plzzz...thanks..