Your new topic does not fit any of the above??? Check first. Then post here. Thanks.

Moderator: igrr

User avatar
By labeutte
#82244 hello,
I developed an esp8266 application (c ++) with API arduino. It works fine when I upload it.
How to burn it in the ESP for it starts at boot ?
thanks for answers.
User avatar
By QuickFix
#82262 Just make sure GPIO15 is pulled LOW and GPIO0 (and GPIO2) are pulled HIGH (both using resistors). :idea:

If you're using a NodeMCU or a Wemos (or any other development board), it should run without any alterations or special switch settings.
You do not have the required permissions to view the files attached to this post.