Chat freely about anything...

User avatar
By column
#84774 Hello,
I have strange situation with starting ESP-WROOM-02 with original firmware. I have tested two ESP's in different PCB's and got similar result. I was expecting for ready phrase after I do reset. Instead of that I got garbage:
rl<00>lœ˛|<00>Œlą| Œ lģ b|ˇ‚ģ’r’bŒ bŒņnn˛lnnœāģ brpģˇlrlrl˛n˛ģ|ņŒœn|<00> nn|’`
72 6C 00 6C 9C 9E 7C 00 8C 6C E0 7C 02 0C 0C 0C 8C 0C 6C EC 0C 62 7C 8E 82 02 EC 12 92 72 92 62 8C 0C 62 8C F2 6E 6E 9E 6C 6E 6E 9C E2 EC 0C 62 72 70 EC 8E 6C 72 6C 72 6C 9E 12 12 6E 9E EC 7C F2 02 8C 9C 6E 7C 00 0C 6E 6E 7C 90 92 60 02

Baud rate 14400

I was tested all communication baud rates. System also not responds to AT commands.

I took new ESP from sealed box and did brand new board according schema below, but got the same result.

How to fix that problem?
User avatar
By QuickFix
#84777 That's not a problem, but a boot-message at 74880 Baud (yes I know: this is not a standard Baud rate) and looks something like this:
Code: Select allets Jan 8 2013,rst cause:2, boot mode:(3,6)

load 0x4010f000, len 1384, room 16
 tail 8
 chksum 0x2d
 csum 0x2d